– 32 –
When installing the door gasket, it is helpful to fold
the gasket in half and locate the center clip. Insert
the clip at the top of the door and work your way
around the door.
Make sure the gasket is cross tucked in the
bottom slots of the inner door panel. Use a small
screwdriver to tuck the loose ends of the gasket into
the slots. The overlap is required to ensure a proper
door seal.
Cross Tuck
Storage Drawer Removal
To remove and replace the storage drawer:
Pull the drawer out until it stops. Lift the front of the
drawer until the stops clear the guides. Pull forward
and remove the drawer.
To replace the storage drawer, place the drawer rail
in the guides and push the drawer in until it stops.
Lift the front of the drawer and push in until the
stops clear the guides. Lower the front of the drawer
and push in until it closes.
Rail
Guide
Stop
Stop
Range Removal
WARNING:
Shut off gas to the range before range
removal.
Caution:
Take the necessary precautions to protect
the
fl
oor from damage caused by moving the range.
To remove the range:
Note:
It may be helpful to remove the door to
lighten the range for removal. (See
Oven Door
Removal
.)
Remove the storage drawer.
1.
Carefully pull the range out until the rear
2.
leveling leg has cleared the anti-tip bracket.
Unplug the range.
3.
Disconnect the gas supply connector.
4.
Using an adjustable wrench, screw the back
5.
leveling legs out to raise the rear of the range
above the counter.
Lift the front of the range up while carefully
6.
pulling the range from the installation.
Continue to pull the range out while lifting up
7.
until the back of the range is accessible.
Note:
Make sure the anti-tip bracket is installed
correctly before pushing the range back into place.
