– 38 –
Bearing
Drum Shaft and Bearing
The drum shaft is attached to the rear of the drum
with three T-20 Torx screws. The bearing can be
removed by pulling it off the shaft. The drum shaft
and bearing
fi
t into the bearing retainer in the
center of the heater assembly (electric models) or
diffuser assembly (gas models).
To access the drum shaft and bearing, it is
necessary to remove the drum. (See
Drum
.)
Drum Shaft
Dual Idler Assembly
WARNING:
Sharp edges may be exposed when
servicing the dryer. Use caution to avoid injury.
Wear Kevlar gloves or equivalent protection.
The dual idler assembly maintains proper tension
on the drive belt to minimize belt slippage. The dual
idler assembly consists of two idler pulleys that
rotate on two idler arms. The pulleys are retained
on the idler arms using cap nuts. The assembly is
attached to the front of the motor baseplate with a
7/16-in. shoulder bolt.
Dual Idler
Assembly
Summary of Contents for Profile DPVH880EJ
Page 27: ... 27 Airflow Gas Dryer Electric Dryer ...
Page 31: ... 31 Control Board Assembly Electric and Gas Models Front View Rear View J3 ...
Page 66: ... 66 Drum Motor Circuit Electric Models Drum Motor Circuit Gas Models ...
Page 67: ... 67 Blower Motor Circuit Electric Models Blower Motor Circuit Gas Models Gas Valve Circuit ...