GE PanaFlow HT, User Manual

Page: 70 / 163

Chapter 3. Initial Setup and Programming
60 PanaFlow HT User’s Manual
3.7.3b Setting the Pulse (cont.)
To change the
Error Handling
status, select it on the screen and press
[

]
. The
following screen appears.
Select
Hold
or
Stop. Hold
directs the meter, in case of a flow measurement error,
to keep sending the pulses sent at the last good reading.
Stop
directs the meter, in
case of measurement error, to stop pulsing. Press
[

]
, and the screen returns to the
previous display. Press
[

]
to return to the
Digital Output Menu
.
3.7.3c Setting the Frequency
Frequency sends out a continuous square wave, with the frequency proportional
to a measured value. To set the Digital Output as a frequency output, in the
Digital
Output Menu
select
Frequency
and press
[

]
. The following screen appears.
To set the measurement type, select
Measurement
and press
[

]
. The following
screen appears.
Select the type of measurement to be used and press
[

]
. The screen returns to the
Frequency
display. Two examples are shown on the next page.