P
ROGRAMMING THE LOCATIONS
LOCATION 0
MODULE MODE OF OPERATION FEATURE SELECTION (8 segments)
This location contains the system characteristics.
Segment 1
1 = Enable site initiated downloading (*98 from a keypad)
2
=
Enable remote initiated downloading
This setting enables the PC to dial into the NX-7002. It is dependent on
other settings (segment 3, 5 and 6).
3
=
Remote initiated download must be from known source
If enabled, program the phone number of the PC in location 168.
4
=
Enable remote download at test time
This setting configures the NX-7002 to automatically dial the PC to
initiate an upload/download session after an autotest. You must
program the autotest in the control panel.
5
=
Enable auto-answer incoming CSD GSM download call.
If enabled, the NX-7002 will automatically accept an incoming call.
If disabled, the user needs to accept an incoming call (*99) as soon as a
“ding-dong” is heard on the keypad.
6
=
Callback required for incoming CSD GSM download call
If enabled, the NX-7002 will call back to the PC before starting an
up/download session.
7
=
Use V.110 for site-initiated CSD GSM calls
Enable this setting if the PC is on an ISDN line and is using an ISDN
modem.
8
=
Use non-transparent mode for site initiated CSD GSM calls
If you are experiencing problems with upload/download, change this
setting from transparent mode to non-transparent mode or vice versa.
Segment 2
1 = Use SIA DCS as backup format (Contact ID if off)
This setting selects the reporting format when using another device as
backup. The same format must be set on the backup device.
2-8
Reserved
Segment 3
1 = Reserved
2
=
Polling enable for TCP/IP (for UL AA)
If polling is enabled, set the polling period in location 162, segment 6.
3-8
Reserved
Segment 4
1-3 Reserved
4 = TCP/IP reporting in SIA (Contact ID if Off)
5-8
Reserved
Segment 5-8
Reserved
NX-7002 Installation manual
Page 13
09/02/05
