LOCATION 162
TIMERS AND COUNTERS (16 segments, numerical data)
Location 162 contains the duration of various system timing functions.
Segment 1
Max Number of network attempts
The number of report attempts the NX-7002 GPRS module makes to send
a report. This can be from 0 to 15.
Segment 2
Report attempts for FTC
The number of attempts that can be made to a specific report destination
before the Fail to Communicate condition is set. This can be from 1 to 15.
Segment 3
Maximum reports in 24 hours
The NX-7002 GPRS module stops reporting messages when the number
of messages in a 24-hour time frame exceeds this number. This can be
from 1 to 255. If set to 0, there is no limitation.
Segment 4
Time in seconds for overall network attempt
The maximum length of time for each attempt by the NX-7002 to report
to each receiver. If the report is not successful during this time, the
attempt is abandoned. This can be from 0 to 255 seconds.
Segment 5
Reserved
Segment 6
TCP/IP Polling time in minutes
This setting must match the TCP/IP polling time set on a TCP/IP receiver.
The setting on the TCP/IP receiver is determined by the speed of the GPRS
network and cost of data transmission. This can be from 1 to 255. If set to
0, the setting is disabled.
Segment 7
Reserved
Segment 8
Reserved
Segment 9
Reserved
Segment 10
Baud rate for CSD/GSM download
This setting must match the baud rate set on the PC modem. 4=2400
Baud, 5=4800 Baud, 6=9600 Baud.
Segment 11
GSM line fault RSSI threshold
The acceptable level of the RSSI signal. If the signal falls below this level
for the amount of time set in segment 12, a line fault is generated. This
can be from 1 to 31. If set to 0, the setting is disabled.
Segment 12
GSM line fault time
The length of time the RSSI signal must be below the RSSI threshold
before a line fault is generated. This can be from 0 to 255 seconds.
Segment 13
Control reporting timeout for secondary reporting
The maximum time during which the control panel must report an event.
If the NX-7002 report control (SMS or TCP/IP report control) is set for
secondary reporting and the control panel does not report the event
during this time, the report control reports the event. This can be from 1
to 255 seconds. If set to 0, the setting is disabled.
Segment 14
Reserved
LOCATION 163
SMS 1 PHONE NUMBER (20 segments)
The phone number to which SMS reports are sent. This phone number is independent from the
phone numbers programmed in the control panel. “14” indicates the end of the phone
number. Program “11” to insert “*” in the phone number, program “12” to insert “#” and
program “13” to insert “+”. It is recommended to add the country prefix before the number. For
example, +32 followed by the phone number.
NX-7002 Installation manual
Page 20
09/02/05
