GE Multilink ML3000, Instruction Manual, Page: 81 / 356

CHAPTER 5: IP ADDRESSING IP ADDRESSING
MULTILINK ML3000 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL 5–7
The ML3000 will time out an idle telnet session. It may be useful to see who is currently
connected to the switch. It may also be useful for a person to remotely terminate a telnet
session. To facilitate this, the ML3000 supports the following two commands:
show session
kill session
id=<session>
For example:
ML3000#
user
ML3000(user)##
useraccess user=peter service=telnet enable
Telnet Access Enabled.
ML3000(user)##
exit
ML3000#
show session
Current Sessions:
SL# Sessn Id Connection User Name User Mode
1 1
163.10.10.14 manager Manager
2 2 163.11.11.1 peter Manager
3 3 163.12.12.16 operator Operator
ML3000#
kill session id=3
Session Terminated
ML3000#
In the above example, the user with username “peter” is given telnet access. Then multiple
users telnet into the switch. This is shown using the
show session
command. The user
operator session is then terminated using the
kill session
command.
NOTE
Note
A maximum of four simultaneous telnet sessions are allowed at any time on the switch.
The commands in these telnet windows are executed in a round robin fashion; that is, if
one window takes a long time to finish a command, the other windows may encounter a
delay before the command is completed. For example, if one window is executing a file
download, the other windows will not be able to execute the command before the file
transfer is completed. As well, if a outbound telnet session is started from the switch
(through a telnet window) then other windows will not be able to execute a command until
the telnet session is completed.