GE Multilin F650, User Manual

Page: 86 / 323

3-20 F650 Digital Bay Controller GEK-106310AE
3.1 ENERVISTA 650 SETUP SOFTWARE INTERFACE 3 HUMAN INTERFACES. SETTINGS & ACTUAL VALUES
3
3.1.8 SETPOINT MENU OVERVIEW
Table 3.5: GENERAL OVERVIEW OF SETPOINT MENU IN ENERVISTA 650 SETUP:
Options enabled only in On-line mode are marked as (*). Options enabled only in Off-line mode are marked as (**)
3.1.8.1 PRODUCT SETUP
Table 3.6: GENERAL OVERVIEW OF PRODUCT SETUP MENU:
Options enabled only in On-line mode are marked as (*). Options enabled only in Off-line mode are marked as (**)
SETPOINT
Product Setup
Communications settings for all protocols and physical mediums.
ModBus user map definition, fault report, oscillography, data logger
demand settings and Time Settings.
System Setup
General Settings, Flex Curves Definition, Breaker settings maintenance,
switchgear snapshot events management and Miscellaneous Settings.
Protection Elements
Phase, Neutral, Ground, Sensitive Ground and Negative Sequence
Current Settings. Voltage Elements settings and Power Settings
management.
Control Elements
Setting groups, under and overfrequency settings, synchrocheck,
autoreclose, breaker failure, VT fuse failure, broken conductor, locked
rotor settings management, Pulse Counters, Analog comparators,
Frequency Rate of Change, Load encroachment, max number of starts,
Digital Counters, Cold Load Pickup and PLC Timer Masks
Inputs/Outputs
Contact I/O settings for all boards available in device, Remote Comms
Force Outputs and Virtual inputs.
Quick Settings
Menu that encompass the most important settings to configure the
device such as; Current and Voltage sensing or current protection
element.
Relay Configuration
Configuration of Outputs, LEDs, Operations, Protection Elements,
Oscillography, Control Events, Control Elements, Switchgear, Inputs,
Virtual Inputs, Operations and HMI. Whole relay configuration with
internal relay signals or user-definable ones as logic (virtual outputs).
Logic Configuration
Logic configuration graphic editor (PLC Editor). It is a PLC Project file
editor that contains all the internal drawings used to make the logic
(virtual outputs) based on IEC 61131-3 standard. Functional block
diagram (FDB).
Procome Configuration
Procome Configuration tool. Only available for Procome models (5)
when communicating through Ethernet with EnerVista 650 Setup
IEC103 Configuration
IEC103 settings for available IEC103 models (3) when communicating
through Ethernet with Enervista 650 Setup
Clock (*)
Relay synchronization to computer clock or to user-definable date and
time. On-line mode only.
PRODUCT
SETUP
Communication
Settings
Serial Ports, Network (Ethernet), ModBus Protocol, DNP Slave, IEC 870-
5-104, SNTP settings and procome (if available on model selection),
PTP1588 and Routing (for firmware version 7.00 and higher)
ModBus User Map
ModBus user map definition. The ModBus user map is formed by 256
records, selectable from the complete relay ModBus map.
Fault Report Fault report settings. Possibility to show fault reports on HMI screen.
Oscillography
Oscillography settings (trigger position, samples per cycle, etc.). The
trigger and digital channels (up to 16) must be configured in
" Setpoint>Relay configuration ".
Data Logger Data logger configuration
Demand
Demand settings. The demand trigger and demand reset signals must be
configured in " Setpoint>Relay configuration "
Time Settings Time settings.