MDS 05-4846A01, Rev. C
SD Series Ref. Manual (Packet & Transparent Mode)
71
2. Enter the desired port number, followed by
to apply the
change. Port numbers below 2000 should be avoided, as some are
reserved for special applications in data networks.
TCP Keepalive Time
This setting specifies the number of seconds that the TCP socket is
active after the receipt of data. To set the time, proceed as follows:
1. Select
TCP Keepalive
on the menu. The field to the right of the item
clears and a flashing cursor appears.
2. Enter the number of seconds for the TCP socket to remain active
after the receipt of data, followed by
to apply the setting.
Restoring
Configuration
In some cases, you may wish to revert to the previous configuration of
the menu, prior to any changes being committed. This might be useful if
one or more settings were inadvertently changed and you wish to return
to a known menu state. To restore the menu settings, simply select
Restore Configuration
. The message
Configuration restored
appears at the
bottom of the screen to confirm the action.
Committing
Configuration
Settings
Once you are satisfied with all of the settings on the menu, you make
them active by selecting
Commit Configuration
on the menu. The message
Changes committed
appears at the bottom of the screen to confirm the
action.
6.11 Serial Configuration
This section explains the settings for the
COM1
and
COM2
serial ports of
the transceiver. These settings are accessed from the Serial Configura-
tion Menu (Figure 55).
Invisible place holder
Figure 55. Serial Configuration Menu
ENTER
ENTER
