MDS 05-4846A01, Rev. C
SD Series Ref. Manual (Packet & Transparent Mode)
57
Invisible place holder
Figure 45. Diagnostic Settings Menu
Unit #
This parameter identifies the radio in the wireless network with a spe-
cific ID during diagnostic sessions. To change the setting, proceed as
follows:
1. Select
Unit #
from the menu. The field to the right of the item clears
and a flashing cursor appears.
2. Enter the desired 4-digit unit ID number and press
to apply
the change.
DLINK Type
This setting identifies the radio as either a
Node
,
Root
,
Repeater
,
Peer
,
or
Gate
. Each of these are operating modes of the transceiver with
respect to diagnostic/management activities. (See “Performing Net-
work-Wide Remote Diagnostics” on Page 97 for details. To make
changes to this setting, proceed as follows:
1. Select DLINK Type from the menu. A flashing cursor is presented
in the field to the right of the item.
2. Press the spacebar until the desired entry is shown, and press
to apply the change.
DLINK Status
This item is used to enable or disable diagnostics functionality. Setting
it to
ON
configures the radio to pass the diagnostic link protocol
(DLINK) over the radio’s
COM1
management port. To make changes to
this setting, proceed as follows:
1. Select
DLINK Status
from the menu. A flashing cursor is presented in
the field to the right of the item.
2. Press the spacebar until the desired entry is shown (
Diagnostic Link is
ON
or
Diagnostic Link is OFF
), and press
to apply the change.
ENTER
ENTER
ENTER
