49-2000738 Rev. 0
15
Installation Instructions
PREPARING THE OPENING
1
7KHIROORZLQJ0,1,080FOHDUDQFHGLPHQVLRQV
must be maintained.
2
Overall Cooktop Dimensions
3
One and one-half inches
s
) minimum
vertical clearance
between the cooktop
bottom and any
combustible surfaces.
13
s
MAX. depth of unprotected
overhead cabinets
30
s
0,1
clearance from
countertop to
unprotected
overhead
surface
s
0,1FOHDUDQFH
from cutout to side wall
on the left of the unit
18
s
0,1KHLJKW
from countertop
to nearest cabinet
on either side of
unit
s
0,1
clearance from
cutout to side
wall on the right
of the unit
s
Min.
Vertical Clearance
If a 30
s
clearance between the cooking surface
and overhead combustible materials or metal
cabinets cannot be maintained, a minimum
clearance of 24
s
is required and the underside
of the cabinets above the cooktop must be
SURWHFWHGZLWKQRWOHVVWKDQ
s
insulating
millboard covered with sheet metal not less
than 0.0122
s
thick.
s
Cooktop
s
s
s
s
4
Optional Installations
Dimensions And Clearances
To ensure accuracy, it is best to make a
template when cutting the opening in he
counter.
Horizonta Installation With Controls at the
Front
In this installation, the cooktop must be installed with
the control knobs toward the front edge.
VERTICAL INSTALLATION MUST BE ORIENTED
WITH CONTROLS ON THE LEFT SIDE
To eliminate the risk of burns by reaching over a
heated surface, the cooktop must be installed with
the controls on the left side.
In this installation, countertops must be at least 25
s
deep. Observe all minimum clearances at the front,
rear and sides.
Make sure
the wall
coverings,
countertop
and cabinets
around the
cooktop can
withstand
heat (up
to 200°F)
generated by
the cooktop.
s
0,1IURPIURQW
edge of cutout and front
edge of countertop
s
depth
of cutout
s
width
of cutout
2
s
0,1EHWZHHQ
cutout and the wall
behind the cooktop
s
0,1FOHDUDQFH
from cutout to left or
right side walls
s
0,1IURPIURQWHGJH
of cutout and front edge of
countertop
s
depth
of cutout
2
s
0,1EHWZHHQ
cutout and the wall
behind the cooktop
s
0,1FOHDUDQFH
from cutout to left or right
side walls
s
width
of cutout
Wall coverings,
cabinets and
countertop must
withstand heat up
to 200°F.
INST
ALLA
TION INSTRUCTIONS
Summary of Contents for JP3021
