❑
IF
LIGHT
BURNER
1. Purge
air from supply system by turning
one top burner valve
ON for 15 seconds.
2. Turn valve OFF and
pilot burners.
Adjust pilot flames using adjusting screw at the
manifold pipe, so that each flame is
in height.
3. To
any top burner, push and turn burner
knob to the
position.
4.
burner has ignited, rotate knob to
desired flame setting.
Surface
Burner Pilot
(If equipped)
Pilot Flame
Pilot Adjustment Screw
Pilot
Right Pilot
❑
IF
ELECTRIC
There are separate ignition devices for the left
and right
surface burners. Both of these
igniters are ON when any knob is turned to the
The igniters
“spark” as long as
any of the top burner knobs are at the
setting.
the event of an electrical power failure, the top
burners
be used. To
a burner, hold
a
kitchen match adjacent to the top
burner to be used and turn valve knob to
USE
❑
OVEN PILOT
On pilot models remove thermostat knob.
Check position of
gas selector to make sure
selector is turned to the correct position for the
type of gas that is to be used. To change to
insert
blade screwdriver in slot and turn
counterclockwise so that indicator points to
To change to NAT, turn fully clockwise so
that
to
●
the
oven
be
turned off
the selector so
pointer is at
position,
between the
and NAT
on your
may not appear
as shown in
●
On electric
models
to the
oven burner
be turned off. A
shut-off
is provided on manifold pipe.
31