Lighting Instructions for Electric Ignition Models
The surface burners on some models
lighted by
electric ignition, eliminating the need for standing pilot
The electrode of the spark igniter is exposed.
flames.
one burner is turned to
burners
In
of a power failure, you can light the surface
spark. Do not attempt to disassemble or clean
burners on your range with a match. Hold a
around any burner while another burner is on.
match to the burner, then turn the knob to the
An electric shock may result, which could cause
Use extreme
when
burners
you to knock over hot cookware.
I
way.
--
Surface burners in use when
electrical power failure
occurs will continue to operate normally.
Lighting Instructions for Standing
Models
The surface burners on these ranges have standing
pilots that must be initially. To light them:
1. Be sure surface burner control knobs are in the
position.
-
2. Remove the grates and lift the
up (see the
section).
3. Locate the 2 pilot ports
light each of them with
a match.
pilot
adjustment
screw
pilot
tubes
pilot
filter
manifold
manifold
panel
pipe
4.
If the pilots need adjusting, turn the adjusting screw
located on the pilot filter.
5. Lower the
Your surface burners are now
ready for use.
6. Observe lighted burners. Compare the flames to
pictures in the Problem Solver. If any flame is
unsatisfactory,
for service.
Surface Burner Controls
Before Lighting a Burner
The knobs that turn the surface burners on and off are
●
If drip pans are supplied with your range, they
located on the control panel on the front of the range.
should be used at
times.
The two knobs on the left control the
front and
left rear burners. The two knobs on the right control
●
Make sure
the grates on the range are in place
right front and right rear burners.
before using any burner.
8