GE Invenia ABUS 2.0, Technical Publication

Page: 151 / 278

General procedures
Invenia ABUS 2.0 – System Setup and Basic Service Manual 4-5
4700-0043-00 Rev. 4
Connect AC (mains) Power to the Invenia ABUS 2.0
Connecting AC Power to the Invenia ABUS 2.0 ultrasound unit,
involves preliminary checks of the power cord, voltage level and
compliance with electrical safety requirements.
1. Ensure that the wall outlet is of appropriate type, and that
the Power Mains Switch is turned off.
2. Uncoil the power cable, allowing sufficient slack so that the
unit can be moved slightly.
3. Verify that the power cable is without any visible scratches
or any sign of damage.
4. Verify that the on-site mains voltage is within the limits
indicated on the rating label near the Power Mains Switch
on the rear of the unit.
5. Connect the Power Cable’s female plug to the Power Inlet at
the rear of the unit.
6. Verify that the Power Mains Switch is in OFF position, if not,
switch it OFF.
7. Connect the Power Cable’s other end (male plug) to a
hospital grade mains power outlet with the proper rated
voltage, and the unit is ready for Power ON/Boot Up.
Switch ON the AC Power to Invenia ABUS 2.0
1. Switch ON the Power Mains Switch at the rear of the unit.
Figure 4-2. Power Mains Switch