Euro Simon Security System
4
Device Locations
Control Panel
Locate the panel where alarm sounds can be heard and is easily accessible for operation.
Do not install the panel near a window or door where it can be reached easily by an intruder.
Remote Handheld Touchpad
Locate Remote Handheld Touchpads where they will be convenient and offer quick access to the
user.
Keychain Touchpad
Keychain Touchpads attach to the owner’s key ring or can be conveniently carried.
X-10 Modules
The system can control up to 8 individual unit numbers on Lamp, Appliance, and Universal Modules.
House Code and Unit Numbers
Note
All Lamp Modules with the
same house code will turn
on or flash as a group during
an alarm or when operating
the “Light” button on a Key-
chain Touchpad.
Each device (lamp, appliance, etc.) controlled by the panel must have an identification setting.
The modules use two dials to set identification codes: one with letters A through P and one with
numbers 1 through 16.
The lettered dial sets the house code, which enables the system to differentiate this home from
other homes in the area. Set all modules (except the remote siren) and the panel to the same
house code.
Note
When unit numbers 9-16 are used for lamp modules, they can only be controlled by an all on or all off
command. A lamp will flash to the arming level if its unit number is set to 10. A lamp set to unit number
10 will flash once if the panel is disarmed, twice if doors & windows are armed, etc. The remote siren
can be set to any unit number to hear alarm sounds. Set it to unit number 9 to also hear arming level
beeps, status beeps, and trouble beeps. Do not use a lamp module to control appliances. Use an appli-
ance module, since the wattage rating on Lamp Modules is less than on Appliance Modules.
The numbered dial sets the unit number, which identifies and lets you control a specific device.
Each device must have a unique unit number (1-8) to be individually controlled. For example,
lights and appliances operated from a Remote Handheld Touchpad or operated by a sensor; or
lights programmed to go on during the entry/exit delay or at scheduled times.
¾
To Fill Out the Home Control Planning Table:
1. Set the house code on all modules (except the remote siren) to the same letter.
Note
The house code instructions
that come with the Power-
horn Siren won’t work with
this panel. Follow the house-
code instructions given here.
2. Set the Remote Siren house code to the next alphabetical letter. For example, if you chose
house code B in step 1 above, set the remote siren house code to C.
3. Set the module unit numbers.
Note
If you are using a Universal
Module to operate a device,
make sure to assign a
unique unit number to this
module, choosing from 1-8.
4. List the location of the lamp or appliance in the Location column of the Home Control Plan-
ning Table.
5. Write the location of each module on an adhesive note and label the module.
6. Decide if the device should be activated by sensors, entry/exit delay, time, or a combination.
An example of sensor activation is using a motion sensor to turn on a light. Record the infor-
mation in the appropriate columns.
Use the following tables to help plan X-10 module installation.
House Code Assignments
House Codes
Results
A through P
Set all modules to the same house code except the remote
sirens.
Next Higher House Code
Remote Siren must be set to the next higher alphabetical letter.
Summary of Contents for Euro Simon
Page 55: ...Euro Simon Security System 50 ...
