Euro Simon Security System
27
Option 42: Speaker Level (Default = 8)
Sets the volume of voice messages from the panel speaker.
The volume can be set from 1 (lowest) to 8 (highest). Turning off this option returns the setting
to the default value.
¾
To set Speaker Level, press:
Add—Option #—42—1 - 8—DONE.
¾
To turn off Speaker Level (return to default), press:
Delete—Option #—42—DONE.
Option 43: Voice Event Notification Phone Number (Default = off)
Lets you program up to a 26-digit phone number for voice event notification (on), or delete an
existing phone number (off).
When programmed, a person at the remote phone location can hear system voice alarm
announcements. See the “Testing” section for more information.
Press Test for each required pause, Add for a *, and Delete for a # (each of which uses one of
the 26 available places).
¾
To set Voice Event Notification Phone Number, press:
Note
Pressing DONE is required if
you enter fewer than 26 dig-
its. The phone number is
automatically stored without
pressing DONE if all 26
places are used.
Add—Option #—43—Up to 26 digits—DONE.
¾
To delete Voice Event Notification Phone Number, press:
Delete—Option #—43—DONE.
Option 44: Voice Event Notification Phone Mod 3 (Default = 09)
Determines the report content and reporting format when Option 43: Numeric Pager/Voice
Event Notification Phone Number is programmed. The following table describes the choices.
All entries must be 2 digits.
¾
To set Voice Event Notification Phone Mod 3, press:
Add—Option #—44—10—DONE.
¾
To reset Voice Event Notification Phone Mod 3 (return to default), press:
Delete—Option #—44—DONE.
Option 45: Sensor Alarm Restoral Report (Default = off)
Determines whether the panel reports sensor alarm restorals (on), or not (off). The following
table describes the possible settings.
Phone Mod 3
Setting #
Content
Format
08
Latchkey, No Activity, Phone Test, Openings, Closings,
Fail to Open/Close, AC Power Restorals/Failures
Numeric Pager
09
Same as setting 8 plus Alarms
Numeric Pager
10
Alarms only
Voice Event Notification
Sensor Alarm Restoral Settings
Setting
When Restorals are Reported
Off
No restoral reporting
1
Immediately after sensor is closed or
restored
2
After siren timeout expires
3
When system is disarmed
Summary of Contents for Euro Simon
Page 55: ...Euro Simon Security System 50 ...
