GE Euro Simon, Installation Instructions Manual

Page: 20 / 56

Euro Simon Security System 15
¾
To add a hardwire or RF sensor or remote control:
1. Press Add. The panel announces “Select from Main Menu.”
2. Press Sensor/Remote. The panel announces “Press button on sensor.”
3. Press the sensor program button or release sensor tamper switch. The panel announces
“Keychain Remote. Press sensor again for next name or press Done to select.”
4. Press Sensor/Remote repeatedly until you hear the name or item you want to use. An
alphabetical list of names the panel uses appears in Appendix B. Each name may be used
more than once.
Note
For a more specific location
name, press Option # for
compass directions (north,
northeast, east, southeast,
south, southwest, west,
northwest).
5. Press DONE when you hear the desired name. The panel announces “Use numbered keys
to enter sensor group.”
6. Enter the 2-digit sensor group. The panel announces the first available sensor number and
sensor group, then prompts you to press DONE to accept.
Note
If you wish to use a sensor
number other than the next
one available, use the num-
bered keys to enter a 2 digit
sensor number immediately
after entering the sensor
type.
7. Press DONE. The panel confirms programming by announcing the sensor number, name,
and group.
¾
To delete sensors:
1. Press Delete. The panel announces “Select from Main Menu.”
2. Press Sensor/Remote repeatedly until you hear the name and number you want deleted,
then press DONE. The panel announces that the sensor is deleted.
X-10 Module Operation
Use the following procedure to program X-10 module operations into panel memory. Notice
that the Light Control button is used to program all X-10 module operations (light, appliance,
and universal).
¾
To program the house code:
1. Press Add.
2. Press Light Control repeatedly until you hear the desired house code letter.
3. Press DONE.
4. Set the HOUSE dial on each lamp, appliance, and universal module, to the same letter.
5. Set the HOUSE dial on powerhorn/remote sirens to the next sequential alphabetical letter.
¾
To add an entry/exit activated module:
1. Press A
DD
.
2. Press Light Control.
3 2
9 7 8
1 0
6 4 5
Test
System should be checked
422-2806 Rev A
Set Code
Access Clock
+
Delete
Delete
press
-
+
Hours
at least every three years.
To delete an option or access code
Hold key or press
and follow the voice
repeatedly until you
hear the desired item.
Note:
Cancel
and
Test
Cancel
DONE
Minutes
, then
DONE
See Note
If you make a mistake or want to
Sensor or Phone Test
follow the voice prompting.
To select a test, press
start over press
prompting.
by a qualified technician
Delete
START MENU
Add
Version 3
MAIN MENU
*
Remote
Sensor/
* *
Control
Light
Option #
* *
Sensors
-
*
Entry/Exit
Delay
CONTROL MENU
* Press for program
information.
Instruction
Add Option
Summary
Unit #
Add
Press
Clock Set
Press
Set Clock
DONE
Chime Voice
Latchkey Time
Panel Voice
Add Option #
Press
Option #42:
Option #43:
Option #55:
Option #41:
Option #2:
Option #3:
Option #36:
Option #37:
See Note
Sensor Activated Light Lockout Start Time
Sensor Activated Light Lockout Stop Time
and follow voice prompts.
Pager Phone Number
Speaker Volume
Status Beep Volume
Option #1: Panel Beeps
use red numbers to enter 4-digit code.
Add Access Code
Hours
Access Code
See Note
Minutes
Time
Cancel