Euro Simon Security System
35
Option 78: VOX Receiver Gain (Default = 6)
Determines the receiver gain level during 2-way audio sessions.
If the VOX is switching the speaker on when the central station operator is not talking, lower
both this setting and Option 75: VOX Mic Gain setting. If the VOX is not switching the
speaker on when the central station operator is talking, raise this setting and lower Option 75:
VOX Mic Gain setting.
Note
Changing this setting does
not affect speaker volume.
This option can be set from 01 - 10. Entries must be 2 digits.
¾
To set VOX Receiver Gain, press:
Add—Option #—78—1 - 10—DONE.
¾
To reset VOX Receiver Gain (return to default), press:
Delete—Option #—78—DONE.
Option 79: Panel Cover Tamper (Default = off)
Determines whether the panel activates a tamper alarm anytime the cover is opened (on), or
only when the system is armed (off).
To enter program mode when this option is on, you must first enter the Master Access code,
then open the cover and enter program mode within 10 seconds.
¾
To turn on Panel Cover Tamper, press:
Add—Option #—79—DONE.
¾
To turn off Panel Cover Tamper (return to default), press:
Delete—Option #—79—DONE.
Option 80: Alarm Report Verification (Default = off)
Determines whether the panel verifies successful alarm reports to the central station with the
voice message “Phone communication okay” (on), or not (off).
¾
To turn on Alarm Report Verification, press:
Add—Option #—80—DONE.
¾
To turn off Alarm Report Verification (return to default), press:
Delete—Option #—80—DONE.
Programming System Access Codes
Utility Access Code 1 (Dealer Code)
Depending upon how Option 54 is set, the default utility access code is 654321, 54321, 4321
(factory default), or 321. This code can be used for all programming.
Utility Access Code 2 (Installer Code)
Depending upon how Option 54 is set, the default access code is 654321, 54321, 4321 (factory
default), or 321. This code is limited to changing all but the following: Utility Access Code 1,
Options 4, 5, 6, 8, 9, 12, 13, 54, and 69.
Master Access Code
Depending upon how Option 54 is set, the default Master Access Code is 123456, 12345, 1234
(factory default), or 123. This code is used to: disarm the panel, subdisarm the panel, program
light control, set the system clock, program the master code, program access codes 1-5, pro-
gram the panic code, perform a sensor or phone test, and program options 1, 2, 3, 31, 36, 37,
41, 42, 43, and 55.
Access Codes (1 - 5)
The panel can have up to 5 secondary user access codes. These could be used by children, a
baby sitter, or a service person to disarm (or arm if Option 60 is on). These codes cannot be
used for programming.
Summary of Contents for Euro Simon
Page 55: ...Euro Simon Security System 50 ...
