Modifications reserved
Pagina 52/90
OPM_SPE_XXX_60K_60K_7GB_V010.doc
Operatine Manual
SitePro 60 kVA
5. Printer
Set-up
The UPS is capable of communicating to a serial printer, to printout disparate information.
Please be sure to have a
serial printer
, that is a printer with a serial RS232 interface.
This is the
only
printer-interface supported by the UPS.
PRINTER SETUP
Baud=2400 Parity=O
Bits=8 Handshake=XON
Print All = N
m etering
alarm s
param eters
+
–
ok
Baud Rate
This parameter controls the
baud rate
used for data transmission.
Although different values can be selected, you must select
2400 Baud
, which is the
only valid parameter.
Parity
This parameter controls the parity used for data transmission.
Odd (
O
) even (
E
) and “no parity” (
X
) can be selected.
Nevertheless the only valid value is
NO PARITY (X)
.
Bits
This parameter controls the length of the data word on the serial line during data
transmission
7
or
8
bits are offered as choice.
Please
select
8 bits
, as this is the only valid value.
Handshake
This parameter is used to determine the communication protocol used when printing.
Valid
values
are
“XON”
standing for the
XON/XOFF
protocol or
“NO
” standing for
any
protocol.
Print All
This
parameter
Y/N
is used to print
all the available information
in the sequence
metering
,
alarms
,
user
and
service parameters
.
NOTE !
Please configure your printer with the following parameters: 2400/8/N (2400 bits/sec, 8
bits, no parity).
6. Printer
commands
PRINTER COMMANDS
Print Measures
= N
Print Alarm s
= N
Print Param eters
= N
m etering
alarm s
param eters
+
–
ok
Print Measures
This
Y/N
parameter is used to print
only the measurement data.
Print Alarms
This
Y/N
parameter is used to print
only the sequence of all Alarms/Events.
Print Parameters
This
Y/N
parameter is used to print
only the list of User and Service
Parameters
NOTE !
After each printing command the corresponding parameter will be set again to
N
.
