GE CyberDome II, Installation Manual

Page: 51 / 56

Appendix A
Installing the individual mounts
43
11. Before you attach the housing to the arm, attach the housing safety cable to the arm safety chain
( Figure 26 ).
Note: The safety cable for rugged housings is metal and for plastic housings is a beaded cord.
a. Cut the quick tie on the safety chain.
b. Hold the housing near the arm’s collar.
c. Slide the ball of the safety cable into the clip of the safety chain.
d. Ensure that the safety chain and cable can bear the housing’s weight.
e. Lower the housing until the safety chain and cable are taut.
Figure 26. Attaching the housing safety cable to the arm safety chain
12. Return to Installing the housing on page 15 to finish installing the dome.
Opening a conduit hole
Open a conduit hole for a 3/4 in. or 1/2 in. conduit connector, if you need to bring the facility cables in through
the side of the arm.
To open the conduit hole, see Figure 27 on page 44 and do the following:
1. Locate the dimple on the side of the arm.
2. Drill a 3/8 in. (10 mm) pilot hole through the dimple.
3. Enlarge the pilot hole to 1-7/64 in. (28 mm) for a 3/4 in. conduit connector or to 7/8 in. (22 mm) for a
1/2 in. conduit connector.
4. Return to step 2 of Installing the wall-mount arm on page 40.
Quick tie
Safety chain
Clip
Safety cable