GE CyberDome II, Installation Manual

Page: 11 / 56

Chapter 1
Introduction
3
housing, connectors, and manuals. The PTZ assembly, dome, and mount (for wall-mount versions) are each
shipped in separate boxes.
Inspect the packages and contents for visible damage. If any components are damaged or missing, do not use
the unit; contact the supplier immediately. If you need to return the unit, you must ship it in the original box.
System requirements
For proper operation, adhere to the following operational, load, cable, and power requirements for CyberDome II
domes.
Operational requirements
CyberDome II contains a built-in receiver that decodes commands originating from a compatible controlling
device, such as a keypad or ASCII control software. A minimum of one controlling device is required for
operation. See
Figure 1 . From the keypad, an operator can pan, tilt, and zoom the camera, find presets, and
start preset and ShadowTours. A typical advanced system is shown in Figure 2 on page 4. For additional
details, refer to the data sheet, user manual, or application guide.
Figure 1. Basic point-to-point system
KTD-405 controller keypad Cyberdome II
camera