
Appendix A
Installing the individual mounts
41
3. Remove the access cover (
Figure 22
).
Figure 22. Removing the access cover
4. Using the arm as a template, place it level against the mounting surface and mark the position of the
mounting holes, and if needed, the cable entry hole (
Figure 23
).
Figure 23. Marking the mounting and cable entry holes
5. Following all local codes, drill and prepare the mounting holes, and if needed, cut the cable entry hole.
6. Feed the cables through the cable entry hole in the mounting surface or through the conduit attached to
the opened conduit hole, and up through the arm.
•
Pull enough cable to make connections. You can always pull back unneeded length later.
•
Do not terminate the cables yet. Otherwise, they will not fit through the dust seal of the housing.
•
How many cables you pull depends upon how many video, data, and power cables you are
using. See
Wiring and the dome
on page 19.
Summary of Contents for CyberDome II
