4
49-5000629 Rev. 0
Controls
NOTE:
When the bucket is full or removed, the controls
cannot be set.
1. Power Pad
Press to turn the dehumidifier on and off.
NOTE:
Turning off the power by pressing the Power button
does NOT disconnect the appliance from power supply.
2. Fan Speed Pad
Controls the fan speed.
Press to select either High, Medium, Low, or Smart Dry fan
speed.
Set the fan control to High for maximum moisture removal.
When the humidity has been reduced and quiet operation is
preferred, set the fan control to Medium or Low.
Smart Dry compares the set humidity level with the actual
humidity and adjusts the fan speed automatically.
3. Display
Shows the set % humidity level while setting, then shows the
actual (+/– 5% accuracy) room % humidity level.
4. Humidity Set Control Pads
The humidity level can be set within a range of 35%
RH (Relative Humidity) to 80% RH (Relative Humidity) in 5%
increments or in Nonstop mode for continuous operation. To
set the unit for continuous operation, press the
pad until
the “Nonstop” indicator light is illuminated.
NOTE:
If Nonstop is selected, the dehumidifier will operate
continuously at its maximum dehumidification settings if
attached to a hose to drain or until the bucket is full.
For drier air, press the
pad and set to a lower percent
value (%).
For damper air, press the
pad and set to a higher percent
value (%).
When you first use the dehumidifier, set the humidity control
to 45% or 50%. Allow at least 24 hours for the dehumidifier
to achieve the humidity level. If you still have damper air
than desired, set the humidity level to a lower setting or
select Nonstop for maximum dehumidification.
5. Filter Timer
After 250 hours of operation, the Clean the Filter indicator
light will glow to remind you to clean the filter. Remove the
filter and clean it.
Press and hold
Filter
button for 3 seconds to reset the filter
reminder. See the Care and Cleaning section.
6. Delay Off
While the dehumidifier is operating press the
Delay
button.
Press the
/
buttons to select the number of hours you
want the dehumidifier to continue to operate before turning
Off.
NOTE:
After displaying the time, the Display will revert to
showing the current humidity after 5 seconds have passed.
Pressing the
Delay
button will display the number of hours
left on the delay.
Delay On
While the dehumidifier is off press the
Delay
button.
Press the
/
buttons to select the number of hours you
want the dehumidifier to remain off before turning On.
NOTE:
The display will show the number of hours left until
the dehumidifier turns on.
To cancel the Delay:
Press the
Dela
y button once, the hours remaining on the
Delay will appear on the display. Press the
Delay
button
again and the Delay will be cancelled.
7. Empty Indicator
The “Empty” indicator will blink when the bucket is ready
to be emptied, or when the bucket is removed and/or not
replaced in the proper position.
8. WiFi Connect Pad
Enables connection of the dehumidifier to the home WiFi.
Download
SmartHQ
App for details at:
GEAppliances.com/connect
.
OPERA
TING INSTRUCTIONS
Controls
Appearance may vary by model.
