8. Close window until it touches
air conditioner top bar.
Slide filler panels outward until
they touch window sash tracks.
(Do not release grip on air
conditioner until lower window
sash is in final position. )
9. Secure filler panels by driving
Type A wood screws into lower
window sash through mounting
holes in top slides.
10. Secure bottom of filler panels
by driving Type A wood screws
into window stool through filler
panel tabs.
Cut plastic foam seal to width
of window and install it between
upper and lower
sash.
Attach dial plate and control
knobs.
Attach air filter and front
grille (see page 5).
Window Sash
Slide
e Wood Screw
INSIDE
Window Stool
m“
INSTALLATION IN WINDOW
WIDE
1. Remove both filler panels from air
conditioner cabinet.
2. Open window. Locate and mark two lines 8“ to
left and 8“ to right of centerline.
3. Screw leveling bolt in appropriate 3/8” threaded
hole of support channel. Depth of window sill will
determine which 3/8” threaded hole to use.
4. Place support channel over 8“ line of window sill
with end against window stool. Mark window sill
through Locating Hole A of support channel.
5. Move support channel away from window stool
until Mounting Hole B is over mark on window sill.
Secure the support channel by driving a Type B
wood screw into the window sill through Mounting
Hole B.
6. Adjust leveling bolt so curved top of support
channel is 1/4” below top of window stool.
7.
Repeat steps 3 through 6 for second
support channel.
8. Center air conditioner in window opening
with bottom bar setting behind window stool.
9. Close window until it touches behind air
conditioner top bar.
10. Fasten lower window sash to window frame
(use finishing nails, wood screws or “L” brackets).
If filler is required on sides of air conditioner,
cut plastic foam seal to size and fill both sides.
12. Cut plastic foam seal to width of window and
install it between upper and lower window sash.
13. Attach dial plate and control knobs.
14. Attach air filter and front grille (see page 5).
9
