GE AS0CD09 Series, Technical Service Manual

Page: 33 / 72

31
3) Forming the pipings
1. Wrap the connecting portion of indoor unit with the
Insulation material and secure it with two plastic bands.
(for the right pipings).
•
If you want to connect an additional drain hose, the end of
the drain-outlet should maintain distance from the ground.
(Do not dip it into water, and fix it on the wall to avoid
swinging in the wind.)
In case of the Outdoor unit being installed below
position of the indoor unit.
2. Tape the pipings, drain hose and connecting cable
from down to up.
3. Form the pipings gathered by taping along the
exterior wall and fix it onto the wall by saddle or equiva-
lent.
In case of the Outdoor unit being installed below
position of the indoor unit.
2. Tape the pipings and connecting cable from down to
up.
3. Form the pipings gathered by taping along the
exterior wall, make the Trap to be required to prevent
water from entering the room.
4. Fix the pipings onto the wall by saddle or equivalent.
Trap is required to prevent water from
entering into electrical parts.
Seal a small opening
around the pipings with
gum type sealer.
Taping
Drain
hose
Pipings
Connecting cable
Trap
Seal a small opening
around the pipings
with gum type sealer.