GE AS0CD09 Series, Technical Service Manual

Page: 24 / 72

22
1) Connection of Pipings
1. Remove the indoor tubing with the drain hose from
the retainer clip.
•
Remove tubing holder and carefully, slowly pull the tubing
away from the chassis.
1. Replace the tubing holder into original position.
•
Recommended additional Drain Hose.
* Foamed Polyethylene or equivalents. (ArmaFlex, as
example.)
For right rear piping
3. Route the tubing and the drain hose straight
backwards
4. Insert the connecting cable into the indoor unit
through the piping hole.
•
Do not connect the cable to the indoor unit.
•
Make a small loop with the cable for easy connection later.
5. Tape the tubing, drain hose and the connecting cable.
Be sure that drain hose locates at the lowest side of the
bundle. Locating the upper side can be a reason that
drain water overflows drain pan indoors.
NOTE
If the drain hose will run in the room, insulate the
hose with and insulation material* so that drip-
ping from “sweating” (condensation) will not
damage furniture or floors.
*Foamed polyethylene or equivalent, ARMAFLEX,
forexample.
Tubing holder
To remove the holder,
press the bottom of
chassis near the holder
upward and pull the tab
out of its hole
1
2 Pull
Press
Taping
Indoor/Outdoor
Connecting cable
Gas Side piping
Liquid side piping
Drain hose
Connecting
cable
t r a P t n i o J l a i r e t a M e s o H n i a r D
r e n n I
e z i S
l a i r e t a M
e s o h C V P t f o S
d e d n u o r r u s e b t s u m t I (
n o i t a l u s n I d n a h t i w
) * l a i r e t a M
x a M
" 8 / 5
t f o S
C V P