![background image](http://html1.mh-extra.com/html/ge/aquatrans-at868/aquatrans-at868_abridged-manual_4125785048.webp)
September 2004
3-2
Displaying Data
Setting Up the Display
Follow the instructions in this section to display the desired data on
the display screen (see
Figure A-2
on page A-2 in Appendix A,
Menu
Maps
Accessing the Display
Submenu
1.
Press
[ESC]
,
[ENTER]
,
[ESC]
in sequence to enter the
user program
.
2.
Press [
X
] until
PROG
appears and press
[ENTER]
.
3.
Press [
X
] until
GLOBL
appears and press
[ENTER]
.
4.
Press [
X
] until
I/O
appears and press
[ENTER]
.
5.
Press [
X
] until
LCD
appears and press
[ENTER]
.
Configuring the Display
1.
At
# of LCD PARAMS
, press [
X
] to select the desired number of
parameters to be sequentially displayed and press
[ENTER]
.
2.
For a 1-channel AT868, proceed to Step 4. For a 2-channel AT868,
proceed to Step 3.
3.
Press [
X
] to select the desired channel option and press
[ENTER]
.
4.
At
Measurement Name
, press [
X
] to select the desired parameter
and press
[ENTER]
.
5.
Repeat the two previous steps until all of the specified
# of LCD
PARAMS
have been set up.
Note:
The measurement units that appear in these prompts are those
selected in the
GLOBL-SYSTM
menu as described in Chapter
2,
Programming Site Data.
After leaving the
User Program
, the AT868 will reset and will begin
to display the parameters specified in this section. If more than one
parameter was set up, each of the parameters will be displayed in
sequence, with a pause of several seconds between display changes.
Summary of Contents for AquaTrans AT868
