GE AquaTrans AT868, Abridged Manual

Page: 29 / 67

Programming Site Data 2-3
September 2004
Selecting the Volumetric
Units
1. Use the arrow keys to select the desired volumetric units for the
flow rate display and press
[ENTER]
.
2.
Use the arrow keys to select the desired number of digits to the
right of the decimal point in the volumetric flow rate display and
press
[ENTER] .
Selecting the Totalizer
Units
1.
Use the arrow keys to select the desired units for the totalized flow
rate display and press
[ENTER]
.
2. Use the arrow keys to select the desired number of digits to the
right of the decimal point in the totalized flow rate display and
press
[ENTER]
.
3.
Do one of the following:
•
If MASS FLOW is ON and both channels are active (for
2-channel units only), proceed to
Selecting Mass Flow Units
below.
•
If MASS FLOW is OFF or only one channel is active, the meter
returns to the Channel PROGRAM menu. Go to
Entering
Transducer and Pipe Parameters on the next page.
Selecting Mass Flow Units
1.
Press [
W
]
and [
X
] to select the desired mass flow units for the
flow rate display and press
[ENTER]
. The available units for this
prompt are determined by the selection made at
SYSTEM UNITS
.
2. Press [
W
]
and [
X
] to select the desired time units for the mass
flow rate display and press
[ENTER]
.
3. Press [
W
]
and [
X
] to select the desired number of digits to the
right of the decimal point in the mass flow rate display and press
[ENTER] .
4. Press [
W
]
and [
X
] to select the desired units for the totalized mass
flow rate display and press
[ENTER]
. The available units for this
prompt are determined by the selection made at SYSTEM UNITS .
5.
Press [
W
]
and [
X
] to select the desired number of digits to the
right of the decimal point in the totalized mass flow rate display
and press
[ENTER]
.