Carefully raise window to expose filler panel
locking screws. Loosen screws (Type A) so
panels slide easily.
2. Extend panels to fill window opening
completely and tighten locking screws on top.
3. Close window behind top rail.
WINDOWLOCK
AND SASH SEAL.
YI/
II
Trim sash seal to fit window width and
into space between upper and lower sashes.
2. Attach right angle safety lock with Type B
screw as shown.
3. Position bottom rail seal on bottom rail flush
with front edge of rail and in contact with
side seals.
SLIDE CHASSIS
Be sure handle at bottom of unit is up. Then lift
chassis and carefully slide it into cabinet. Do not
push on controls or finned coils. Make sure
chassis is firmly seated toward rear of cabinet.
9.
DIAL
AND KNOBS
----
If dial plate has a protective film, peel the film off
carefully. Do not scratch the surface of the plate.
10.
‘
-
--
Type E
Screw
Attach the front grille to the unit with two Type E
side retaining screws as shown above.
11