![background image](http://html.mh-extra.com/html/ge/aep23/aep23_use-and-care-and-installation-manual_122182013.webp)
3.
WALL.
4. Caulk all four sides on the outdoor side of
cabinet to prevent moisture from getting
through to the interior wall. Use of flashing (a
piece of aluminum or galvanized steel available
at most hardware stores) will further prevent
moisture from getting into interior walls.
a tight seal along the bottom of the unit,
caulk around the bottom rail. Install wood trim
molding (obtained locally) around
projection of
if desired.
Optional: Support brackets may be used.
Installation of brackets are recommended for
walls under 5“.
Refer to Step 5 of window installation for
assembly of
brackets. A wooden strip
nailed to the outside wall should be used in
conduction with the sill support angle brackets.
strip
4.
CAB/NH
Be sure handle at bottom of unit is up. Then lift
chassis and carefully slide it into cabinet. Do not
push on controls or finned coils. Make sure
is firmly seated toward rear of cabinet.
IFNECESSARY
See page 11, step 9.
Type E
Screw
Attach the front
to the unit with two Type E
side retaining screws as shown above.
13