GDI COMMUNICATIONS Extreme Copper XC-RP300, Owner'S Manual

Page: 7 / 40

INSTALLATION
Since basic XC-RP300 setup requires no configuration, it can be installed and made operational
quickly. Installation takes place as follows:
1. Connect the VDSL line interface between the units (refer to section titled, “Connecting the
VDSL Line Interface” on page 4). See Figure 3 for rear panel connector arrangements.
2. Connect the Ethernet interface (refer to section titled, “Connecting the Switch (Ethernet)
Interface” on page 5).
3. Connect the POTS (Plain Old Telephone System) interface to a telephone or telephone line
(refer to the section titled “Connecting the POTS/ISDN line” on page 6)
4. Connect the power plug (refer to section titled, “Connecting Power” on page 6).
Figure 3.
XC-RP300 rear panel
3
Primary
VDSL Line
Console
Connector
Primary PHONE
Line (POTS)
Secondary
VDSL Line
Secondary PHONE
Line (POTS)
XC-
AC Power Jack
Console Select
Switch
Pri Sec