© GBC Films Group April 2000
Voyager Operation and Maintenance Manual
Page 1 - 50
Troubleshooting
Trouble
10. Web Separates in Wrong
Lap Position
11. Snap Rollers Activating but
Not Separating or Partially
Separating
12. Electrical Malfunctions
Component Not Functioning
Cause / Action
a. Draw roller pressure too tight
b. Knife timing is too early
c. Knife is knicking too far into the lap
d. Lap is too large, leading edge is folding under and catching
on the knife, brush etc.
a. Snap adjusting valves ( flow controls ) not properly adjusted.
b. Skew wheel applying too much or too little bow to the web
c. Exit roller is not applying enough draw pressure to the left
side of the web
d. Insufficient nip pressure applied at laminating process
e. Insufficient nip pressure applied at nip or draw roller
f. Knicking knife not cutting film at lap or cutting into paper
after knicking lap. This condition can happen is lap varies greatly.
g. Full bleed of ink and / or coating of sheets
h. Worn snap roller, exit roller or skew wheel
a. Fuse or circuit breaker blown
b. Disconnected wire
c. Component opened electrical
d. Push reset button
ELECTRICAL
S H O C K
Electrical troubleshooting should be
left to qualified technicians!
Electrical shock hazard!
