© GBC Films Group April 2000
Voyager Operation and Maintenance Manual
Page 1 - 27
Application
5.0 Application
W A R N I N G
Do not wear ties, loose fit clothing or
dangling jewelry while operating or
servicing the laminator. These items can get
caught in the nip and choke you or you can
be crushed or burned.
W A R N I N G
The laminator will only operate if all
E-STOPs are unlatched, safety shields
are in the fully closed position and the
E - S T O P R E S E T i s n o t f l a s h i n g .
Before you begin laminating, check all safety
devices and controls for proper operation.
You will obtain the best lamination by using the
minimum roller temperature, nip pressure, film tension and
brake required to do the job. Read the Over view to
obtain a better understanding of the Voyager before
proceeding.
5.1 Loading the sheets
The first thing to do is switch on electrical power
at the Main Power Switch. Turn on the compressed air
supply and check the supplied pressure at the Air Pressure
Regulator. You need 100 psi ( 700 kp).
To load the sheets, take the following steps:
a. Lower the table.
b. Adjust the table sheet guides apart enough to
accommodate the sheet size to be loaded.
