Ricoh StreamPunch Pro, Pro EX & MP Installation Manual
8
6. Leveling & Height Adjustment
6.1 Height Setting
No height adjustment of the StreamPunch is required, for an installation site with a level floor, when
docking upstream of the SR4050, SR5020, SK5010 or SR5030. If the floor is uneven then it is
recommended to set the level of the StreamPunch using the downstream device as a reference. The exit
guide of the StreamPunch should be set as shown below for the various finisher types. When installing
the StreamPunch upstream of the SK5000, the StreamPunch will need to be lowered by approximately
5mm. Follow the same adjustment procedure as in Section 6.2 and use the table below for a reference
height.
Finisher
Reference Height X
Finisher
Reference Height Y
SR5000
4mm SK5010
2.5mm
SR4050/SR4080
4mm
SR5020
3mm
SR5030/ SR5040
3mm
SK5000*
2.5mm
* Height adjustment required
6.2 Adjusting the Casters
a)
Using a 9/16” (15mm) open ended wrench, loosen
the jam nut(s) situated on the caster stud inside of
the machine
.
b)
Using the 9/16” (15mm) wrench, rotate the caster
stems to change the height.
Re-tighten the jam nuts once the correct height is
achieved.
X
StreamPunch
Output
Downstream
Device Input
Downstream
Device Input
StreamPunch
Output
Y
