Ricoh StreamPunch Pro, Pro EX & MP Installation Manual
2
1. Recommendations and Pre-requisites
•
You will need the installation kit provided with the StreamPunch unit, which can be found in the
main carton.
•
If installing the StreamPunch downstream from a BK5000 Booklet Maker, a cover kit is required.
(Part No US – 404282EDP, EU – 961462EDP, AUS – 7708997)
•
Using a jogging unit on the finisher will improve the stack quality for binding purposes.
•
If installing the StreamPunch directly downstream of Pro C900 series, Pro C651/C751 EX or Pro
C751, contact your local service representative to obtain the correct entrance guide.
2. Unpacking
•
Inspect the outside of the package for shipping damage. If there is evidence of shipping damage,
contact the shipping carrier immediately.
•
Remove the punch from its shipping carton. Three people are recommended, one lifting at the
casters while two lift at the top cover. DO NOT lift using the front door panel.
•
Retain the smaller accessory box; it contains parts required for correct installation of the
StreamPunch.
•
Inspect for any concealed damage to the unit. If there is evidence of concealed shipping damage,
contact the shipping carrier immediately.
•
Remove all shipping tape from doors and levers.
3. Cable Connections
Review the table below to identify which section of the guide to refer to install the StreamPunch Pro/
Pro EX/ MP.
Section Printers
Finisher
3.1
Pro C900 series, Pro C550/700 & MPC6501/7501
SR5000
3.2
MP6001/7001/8001/9001 SR4050
3.2
MP6002/7502/9002 SR4080
3.3
Pro 907/1107/1357EX
SR5020
3.3
Pro C651 EX & Pro C751 EX
SR5030/ SR5040
3.3
MP C8002/ C6502 & Pro C5100S/ C5110S
SR4110
3.3
Pro 8100S/8110S/8120S
SR5050/ SR5060
Refer to the following section when installing the SK5010 downstream of the StreamPunch Pro.
3.4
High Capacity Stacker
SK5010
3.1 SR5000
Finisher
The cables below are required to attach the StreamPunch Pro to this type of finisher.
Finisher to StreamPunch cable
Finisher to printer cable (longer version)
p/n
VR340046
p/n
VRC57001
