Ricoh StreamPunch Pro, Pro EX & MP Installation Manual
4
3.2
SR4050 & SR4080 Finisher
Follow the same steps as in 3.1 but in step a) connect the 7 pin connector into CN138 on the finisher
board.
d) There are two entrance paper guides provided
with the StreamPunch. Use the shorter paper
guide measuring about 12” long when used in
conjunction with the SR4050 finisher. Install the
paper guide, using the size #8 screws provided,
to the lower entrance guide of the StreamPunch.
Go to Section 4 to complete the installation.
3.3
SR5020, SR5030, SR5040, SR5050, SR5060
Finishers
Follow the same steps as in 3.1 but in step a) connect the 7 pin connector into CN110 on the finisher
board.
d) There are two entrance paper guides
provided with the StreamPunch. Use the
longer paper guide measuring about 14” long
when used in conjunction with the SR5020,
SR5030 or SR5040 finishers. Install the
paper guide, using the size #8 screws
provided, to the lower entrance guide of the
StreamPunch.
If installing the StreamPunch directly downstream from the Pro C651/C751 EX or Pro C751, contact
your local service representative to obtain the correct entrance guide.
Go to Section 4 to complete the installation.
3.4
SK5010 High Capacity Stacker
Follow the same steps as in 3.1 but in step a) connect the 7 pin connector into CN150 on the finisher
board and in step b) replace the shorter finisher to printer cable with the longer one provided,
plugging the 8 pin cable in to loose connector and the 9 pin into CN101 on the finisher board.
There are two lower exit guides that can be used with the StreamPunch. The standard 90 degree
bend is used for most configurations and comes ready installed. When the SK5010 is installed
directly downstream from the StreamPunch, the angled guide shown below should be fitted in place
of the 90 degree guide. The angled exit guide is provided with the installation kit.
Standard 90
degree exit guide
Angled
exit guide
Lower exit
guide
