ORCA-I SP Operation Manual
Installation
© GBC Pro-Tech 1998 April
2-1
6HFWLRQ ,QVWDOODWLRQ
Before an ORCA-I SP Laminator can be installed there
are a few requirements that must be met. Make certain
that each of the requirements listed in the following
preinstallation checklist are met before beginning
installation.
CAUTION
3UHLQVWDOODWLRQ &KHFNOLVW
❏
Are doorways and hallways wide enough for the
laminator to be moved to the installation site?
❏
Is there ample room for the laminator?
A work area must be established that allows for
operation in both the front and the rear of the
machine and provides space for efficient material
flow. Figure 2-1 shows a typical machine area lay-
out.
❏
Is the environment appropriate for the laminator?
The laminator requires a clean, dust and vapor free
office environment to operate properly. It must not
be located where there is air blowing directly on
the machine. Provide an environment that does not
have major temperature and humidity fluctuations.
WARNING
WARNING
CAUTION
❏
Has a certified electrician been contacted to both
wire the laminator and ensure that an adequate
power supply is available with the appropriate
capacity, over-current protection, and safety lock-
outs?
The laminator requires 220 to 240 VAC, 50/60 Hz,
55A, single phase 3 wire. Or, in Europe only, 3-N
phase 230/400 VAC, 50 Hz, 25A per phase.
USA - For single phase 3 wire, L1, L2, and L3 are
tied together with a jumper bar on the main termi-
nal block.
Europe - For 3-N phase, L1, L2, and L3 are each
separate phases. The jumper bar must be removed
on the main terminal block.
WARNING
WARNING
Failure to follow the preinstallation checklist can
result in damage to the laminator.
The operating environment must be free of dust,
flammable liquids and vapors. You can be
injured by inhaling chemical vapors. Vapor build
up or stored flammable liquids can cause a fire.
Excessive dust can damage the laminator.
The machine is not designed for use in an
industrial environment.
Do not locate the laminator where air is blowing
directly on the machine. The air flow can cool the
rolls unevenly and result in poor quality output.
Do not operate the laminator if the power cord is
damaged or frayed. You can be severely shocked,
be electrocuted, or cause a fire. Contact a
qualified electrician to replace the cord
immediately.
Do not allow anything to rest on the power cord.
Do not locate the cord where people can walk on
it. You or others can be severely shocked, be
electrocuted, or cause a fire.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500