![background image](http://html1.mh-extra.com/html/gbc/orca-i/orca-i_operation-manual_4064099042.webp)
Maintenance and Troubleshooting
ORCA-I Operation Manual
GBC Pro-Tech 1997 October
4-2
To clean beads of adhesive, dust and dirt from the
rolls:
1.
Allow the laminator to cool slightly to no higher
than 110ºF (43ºC).
2.
Set the FWD/REV switch to the REV position
and use the footswitch to move the rolls as you
clean them. Set the Speed Control to 1.5 fpm.
3.
Clean the rolls using a moderate amount of 80%
isopropyl alcohol on a cotton terry cloth.
CAUTION
Use the minimum amount of pressure
necessary to clean the rolls. You can destroy
the silicone layer on the rolls by pressing to
hard or scrubbing too long in one spot.
WARNING
Exercise care when cleaning the rolls with
80% isopropyl alcohol:
•
Use only in a well ventilated area.
•
Wear rubber gloves.
•
Use only on cool rolls.
Cleaning heated rolls can ignite the fumes.
CAUTION
Use only 80% isopropyl alcohol or a rubber
cement eraser to clean the laminating rolls.
Harsh chemicals like toluene, acetone or MEK
destroy the silicone covering of the rolls.
4.
With the laminator rolls no hotter than 110ºF
remove dust and dirt from the silicone laminating
rolls by running an adhesive-coated board
through the laminator. Be sure to set the nip for
the thickness of the board used.
5.
Allow the laminator to cool.
To clean the cabinet and covers:
WARNING
Remove power from the laminator and make
sure it won’t be reapplied while you are
performing this procedure. You could be
severely shocked, electrocuted, or get your
fingers caught in the drive mechanisms.
Using a damp cotton terry cloth (water only), clean
the exterior of the laminator.
WARNING
Do not use liquid or aerosol cleaners on the
laminator. Do not spill liquid of any kind on
the laminator. You can be severely shocked,
electrocuted or cause a fire. Use only a damp
cloth for cleaning.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500