![background image](http://html1.mh-extra.com/html/gbc/orca-i/orca-i_operation-manual_4064099041.webp)
ORCA-I Operation Manual
Maintenance and Troubleshooting
GBC Pro-Tech 1997 October
4-1
6HFWLRQ
0DLQWHQDQFH DQG
7URXEOHVKRRWLQJ
Performing regular maintenance on the ORCA-I
Laminator is critical to the proper operation of the
machine. A maintenance schedule and a section of
procedures for disassembling and reassembling the
serviceable areas of the laminator are included in this
section.
Table 4-1:
Maintenance Schedule
Daily
•
Clean the rolls
•
Check to be sure nothing is blocking
the IR sensors from reading the roll
temperature
•
Inspect the electrical cord for
damage
•
Inspect the footswitch cord for
damage
Monthly
•
Adjust the nip
•
Align/adjust the IR sensors, if
necessary
•
Check the chain tension
•
Inspect the area around the
laminator for possible hazards (dust
buildup, combustible items stored
too close, etc.)
•
Adjust the air cylinder rates
Every
Six
Months
•
Lubricate the grease fittings and
chain
•
Check wire termination tightness
&OHDQLQJ
Tools required:
•
Adhesive coated board
•
80% isopropyl alcohol
•
Rubber cement eraser
•
Several 100% cotton terry cloths
•
Protective rubber gloves
To clean the laminator rolls:
1.
Lower the infeed table and infeed pressure plate
to gain access to the rolls.
WARNING
Exercise extreme caution while cleaning the
laminator. You can be caught in the turning
rolls and crushed or burned.
2.
While the laminator is at normal operating
temperature, put on the rubber gloves and, using
a rubber cement eraser, remove any heat
activated adhesive from the rolls.
CAUTION
If silicone adhesive contacts the upper or
lower roll, remove it IMMEDIATELY using a
rubber cement eraser. It can harden within an
hour and ruin the roll.
CAUTION
Do NOT pick or pull heat activated adhesive
off the rolls when they are cold. You can cause
irreparable damage to the laminating rolls.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500