GBC GBC Proclick Pronto, Technical & Service Manual

Page: 7 / 92

7
4.0 OPERATING INSTRUCTIONS
The official Operator Manual is available on the GBC Technical Service web site. Be
sure to read the Operator Manual carefully as many service calls related to a new
installation are due to operator misunderstanding of the proper operating procedures.
To avoid duplication of labor to update multiple documents, we will not recreate the
entire Operator Manual in this space, but we offer some key points for the Technician
to be aware of with respect to operation tips.
If the customer runs into difficulty during the installation and set-up of a ProClick
®
Pronto™, keep the following points in mind.
• The P3000 punch and bind combo system is intended for light duty general
office application. For higher production, it is recommended that a customer
use one of the other punch systems made by GBC.
• Time out feature: The ProClick
®
Pronto™ will time out and revert back to the
first step if the bind cycle is not activated for two minutes. This means you will
need to start the sequence over again from the beginning by inserting the
document into the document sizer slot so that the system can identify the
size.
• Alignment of punched holes is extremely critical. If a sheet or two is punched
without care and the holes do not line up, the ProClick
®
Pronto™ will not be
able to force the element spines through the holes to form a proper closure.
If you discover operator errors or confusion not explained in the Operator manual, be
sure to notify GBC Technical Support so that that information may be added to future
versions of either the Operator Manual or the Technical service Manual.
As a supplement to this service manual, a series of videos were shot to acquaint the
Technician with operation tips, repairs and maintenance. Use the videos to obtain a
graphical image of the actions being taken and use the following text as you written
reference notes.
BASIC OPERATION:
Refer to the Video entitled “Basic Operation” as you review the following text.
Power On:
• Turn the power ON, using the I/O switch at the rear of the machine.
• Insert the document to be punched into the punch tray.
• Align paper to the left of the tray.
Note: A maximum of 15 sheets can be punched at a time. Do not attempt to punch
more than 2 plastic covers at a time.
Press the "PUNCH" switch to activate the hole punch (Model P3000 only).