GBC 4064WF
Operation Manual
© 2005 General Binding Corporation
Page 25
- A -
- B -
- A -
- B -
- A -
- B -
Figure 39
Figure 40
Figure 41
Heat
The “READY” indicator may extinguish if the speed is set
too fast for the material being laminated. Either lower the
speed setting or press “STOP” ( ) and wait until the
“READY” indicator illuminates. Operation of the laminator
for more than thirty minutes at a time may necessitate a
lower speed setting. It is recommended that, during periods
of long runs, the items being laminated are alternated
between thick and thin. Do not combine thick and thin
items at the same time, as this will result in a poor edge seal
around the thinner material. If you are unsure that the
laminator is set at the proper speed for the item to be
laminated, run a test piece (scrap) of the same or similar
material through the Laminator. This procedure is
recommended because rotating the heat roller prior to
lamination will more evenly distribute the heat.
Make speed adjustments if necessary.
Output
1.
“D” waves in the image (Fig. 39 A).
•
Check paper tension.
•
Paper may be damp or not dry.
2.
“D” waves in the laminate (Fig. 39 B).
•
Check main roller pressure.
•
Check pull roller pressure.
3.
Straight waves in output (Fig. 40 A).
•
Check operational settings for materials being
used.
•
Check clutch tension.
4.
Indent waves in output after pull rollers (Fig. 40 B)
•
Insufficient cooling time.
•
Output was handled prior to cooling.
•
Use cooling feature if not on.
•
Machine was stopped on print.
5.
Angled waves in the output (Fig. 41A & B)
•
Main air Supply setting
•
Check main Roller Pressure.
•
Check pull roller pressure.
•
Check for Paper Tension.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
