GBC 4064WF
Operation Manual
© 2005 General Binding Corporation
Page 10
Figure 4
B
Figure 5
B
A
A
C
Unwind / Rewind Combo Shafts:
(Fig. 3)
There are two lower combo unwind / rewind
shafts, one on the lower front and one on the
lower back of the machine.
Unwind/rewind combo shafts can be used as
standard swing out unwind shafts for material
supply or be used as rewind shafts for liners and
final products.
The conversion from unwind to rewind just
requires the release of the brake adjust knob
(Fig. 3E) and tightening the rewind adjustment
knob (Fig. 3F).
Note:
When using the combo unwind / rewind shaft
as a rewind. The brake tension knob must be
released to limit the load on the motor, and
wear & tear on the machine.
The film shaft clutch is then engaged to turn
with the motor to wind up the film.
Upper Tension Idler:
(Fig. 4 – Item B)
Upper tension Idler guides the laminating film
onto the main roll insuring a consistent amount
of wrap on the upper rolls.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
