![background image](http://html1.mh-extra.com/html/gbc/930-028/930-028_operating-and-maintenance-manual_4073839017.webp)
F-60+ Operation and Maintenance Manual
Installation
© GBC Pro-Tech 1999 April
2-7
/HYHOLQJ
Tools required:
•
Adjustable wrench
•
Carpenter's level
To level the laminator:
1. Raise each end, remove the castors and install a
leveling pad and stud onto each of the foot brackets
at the four bottom corners of the laminator. Thread
third nut on stud below cabinet.
2. Thread stud into 4 leveling pads and lock down
with nut. Thread second nut onto stud.
3. Place a carpenter's level front to rear across the two
lower tie bars at one end of the machine.
4. Level this end of the machine front to rear, raising
or lowering the leveling pads by adjusting the mid-
dle nuts on the foot bolts.
5. Move the level to the other end of the machine and
level front to rear.
6. Place the level directly on one of the tie bars and
level the machine side to side.
7. Recheck the front to rear level condition to insure
that it has not changed. If it has, repeat the leveling
procedure.
8. When all the measurements indicate that the
machine is level, tighten down the top nuts on the
foot brackets to lock the pads in their current posi-
tion.
6WDUWXS
The first time the laminator is started and every time it
is serviced you should use the following checklist to
confirm that the unit is operating properly and that all
safety mechanisms are functioning.
Startup Checklist
Start the laminator and go through the following check-
list.
❏
Are the emergency stop buttons working?
Push down on one of the emergency stop buttons.
The laminator should stop. Rotate and pull up on
the button and push the reset button on the lower
back of the laminator. The laminator should
resume operation. Always check all buttons.
WARNING
❏
Are the guard table switches working?
With the laminator running, pull the front guard
towards you. The rolls should stop. Move the guard
back in. Press the RUN button on the front control
panel. The laminator should resume operation.
WARNING
❏
Is the footswitch working?
Press the footswitch. The laminator should start
operation. Vary the speed using the footswitch (like
an automobile accelerator) to ensure that the foot-
switch is operating properly at various speeds.
Never operate the laminator unless all of the
emergency stop buttons are functioning properly.
You can be crushed or burned.
Never operate the laminator unless the
mechanical guard system is operating properly.
You can be crushed or burned.
Summary of Contents for 930-028
Page 10: ...Safety F 60 Operation and Maintenance Manual 1 6 GBC Pro Tech 1999 April Blank page...
Page 36: ...Operation F 60 Operation and Maintenance Manual 3 18 GBC Pro Tech 1999 April Blank page...
Page 44: ...Warranty F 60 Operation and Maintenance Manual 5 2 GBC Pro Tech 1999 April Blank page...
Page 46: ...Specifications F 60 Operation and Maintenance Manual 6 2 GBC Pro Tech 1999 April Blank page...