GBC 620os
Operation Manual
© 2007 General Binding Corporation
Page 7
FRONT CONTROL GUIDE
Figure 1
A. LCD Display:
•
The
LCD
will display the settings the machine is
currently set for.
•
Illuminates when the laminator is plugged in and
POWER ON/OFF
is in the on, (I), position.
Displays settings for the top heater, speed, Burst,
and ready/wait.
B. MOTOR SPEED:
•
When pressed, permits increasing or decreasing
of speed by turning the
MOTOR SPEED
and is
indicated on the control panel display. Range is
1-15. The number does not stand for Feet/Minute.
15=40Feet/Minute.
C. LOADING:
•
When pressed, permits the operator to run
product into the heat roll for the purpose of
threading the film.
D.REVERSE:
•
When pressed, and held, reverses the rollers
direction to clear film jams.
E. STOP:
•
When pressed, the machine will stop and the
rollers will not rotate. The rollers will also rise to
the up position.
F. RUN:
•
When pressed, the machine will activate the
rollers for normal operation.
G. LENGTH:
•
You can enter your paper length by pressing
LENGTH
then turning the
MASTER DIAL
to
the desired paper size.
H. BURST:
•
You can determine where and when you want to
activate the
Burst Rollers
by pressing
BURST
and changing the value displayed on the
LCD
by
rotating the
MASTER DIAL
. Values displayed
range from 580-660. A decal is located between
the
Main Rollers
and the
Bursting Rollers
to
determine what value is desired.
I. HEAT:
•
When pressed, permits increasing or decreasing
of the temperature by turning the
MASTER
DIAL
and is indicated on the control panel
display. Range is 32°F-302°F.
J. Reset Button:
•
On the
LCD
, the sheet count will appear
indicating how many sheets were run through the
machine. By pressing
RESET
, the operator and
clear this value returning the count to “0”.
K. MASTER DIAL:
•
Increases (+) or decreases (-) the numeric value
for the selected setting when turned.
L. BURST ON/OFF:
•
To activate the Burst Roller for sheet separation,
press the
BURST ON/OFF
.
M. FAN ON/OFF:
•
When pressed, turns on the cooling fan. When
pressed again, turns off the cooling fan.
N. BURST SPEED:
•
When
BURST SPEED
pressed, the RPM’s of
the Burst Rollers will increase helping to Burst or
Snap stronger films such as Digital Lay Flat.
This is a pre-set speed and can not be changed.
Figure 1
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
