GBC 620OS, Operation Manual

Page: 9 / 23

GBC 620os Operation Manual
© 2007 General Binding Corporation Page 9
FEATURES/ACCESORIES GUIDE
Refer to the following pages for detailed information on the Features.
Figure 1
Figure 2
Figure 3
Figure 4
EMERGENCY STOP BUTTONS
( Fig. 1– Item A )
There are two EMERGENCY STOPS on the laminator.
One is located at the rear of the machine and the other is
located on the front.
To engage, press any
EMERGENCY STOP to stop the
roller movement. To disengage, turn the EMERGENCY
STOP clockwise after the emergency condition has been
resolved.
FRONT SAFETY SHIELD INTERLOCK LATCHES
( Fig.1-Item B )
The Front Safety Shield Interlock Latches ensures that
the Front Safety Shield is inserted properly and if not
engaged, the machine will not operate.
FRONT SAFETY SHIELD
( Fig.2-ItemC )
The Front Safety Shield prevents entanglement,
entrapment, and inadvertent contact with the Heat Roller .
REWINDER
( Fig.2-ItemD )
The Rewinder is used to take up any film that is being slit
via the In-Line Slitters .
FEED GATE
( Fig.2-ItemE )
The Feed Gate controls the images entering the Nip. It
will activate according to the paper size selected on the
display, and give an even and accurate overlap.
FEED BELTS
( Fig.2-ItemF )
The Feed Belts move the images into the Feed Gate and
then into the nip.
TABLE SIDE GUIDES
( Fig.2-ItemG )
The Table Side Guides are adjustable to ensure accurate
feeding.
BURST ROLLER GAP ADJUSTMENT KNOB
( Fig.3-ItemH )
The Burst Roller Gap Knob raises and lowers the Burst
Roller. Depending on the media and film being used, the
operator can raise or lower the Burst Roller to assist in the
Burst or Snapping of the images.
DECURLING ADJUSTMENT KNOB
(Fig.3-ItemI)
The Decurling Adjustment Knob is used in conjunction
with the film shaft brake to increase or decrease the amount
of curl desired by the operator. The
Decurling Bar is
located between the Main Rolls and the Pull Rolls .
FEED INDICATOR LED
(Fig.4-ItemJ)
The Feed Indicator LED will indicate when the next sheet
can be placed on the Feed Table. Sheets should not be
placed until the LED is illuminated.
FEED GATE STOPS
(Fig.4-ItemK)
The Feed Gate Stops can be adjusted up, down, and left to
right to accommodate various media paper thicknesses.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500