GBC 620os
Operation Manual
© 2007 General Binding Corporation
Page 8
FRONT CONTROL GUIDE
Figure 2
LCD Display:
•
HEAT:
This displays the Temperature the
machine is set at.
Figure 2
. indicates the set
temperature is 32*F. To read the actual
temperature of the
Heat Roller
, press and hold
the
MASTER DIAL
. (
See Figure 1
.)
•
WAIT:
After setting the desired temperature, the
LCD
will display “
WAIT
” until the temperature
reaches the set point. After the machine reaches
the set point, the
LCD
will read “
READY
” and
the operator can start running the machine.
•
BURST:
The Burst value tells the laminator
when and where to activate the
Burst Roller
. A
decal located on the side frame between the pull
rollers and the
Bursting Roller
reflects values
from a range of 580-660. To change the location
of the burst, press the
BURST
then turn the
MASTER DIAL
to dial in the desired value in
relation to the decal on the side frame
.
•
SPD:
The Abbreviation “
SPD
” refers to the set
speed of the machine. The range of speed is 1-
15. At speed 01, the machine will run
approximately 3ft/mn. Each increment is equal
to about 3ft/mn.
SPD
15 is 45ft/mn. To adjust
this value, use
MOTOR SPEED
.
Figure 1
.
•
LENGTH:
The value displayed next to length
refers to the sheet size of the media being used.
In
Figure 2
. the medias sheet length is 18 inches.
To adjust the length, press
LENGTH
and use the
MASTER DIAL
to increase or decrease your
sheet size. The sheet size ranges from 8 inches-
30inches and increases by 1/32
nd
increments.
•
SHEET COUNT:
Sheet count will indicate how
many sheets of media were run through the
laminator. To reset the counter to “0”, press
RESET
shown in
Figure 1.
Figure 3
•
HEAT:
(
Figure 3
.) After setting the
Heat Roller
temperature, the laminator is protected with heat
sensor protection. In the event that the
IR
Sensor
fails, or a foreign object such as a misfeed
image blocks the
IR Sensor
, the
IR Sensor
will
detect a sudden/drastic change in temperature and
an alarm will sound and “H-Err”
will appear on
the
LCD
. Stop the laminator by pressing
STOP
,
locate the
IR Sensor
, (
Refer to Know Your
Laminator Section
) and clear the image from the
path of the
IR Sensor.
Rest the alarm by pressing
the
MASTER DIAL
. (
Figure 1.
) At this time,
simply press
RUN
and continue the job.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500