GAUI Hurricane 425, Operating Instructions Manual

Page: 51 / 104

51
3. Adjusting values
• In the setting mode, you will now also hear different signals (see top line of the following table), which repeat in a
continuous loop. The point where the sequence starts again depends on the menu item set, since only those sounds
are emitted for which a value is set and stored as well.
• After the sound signal for the desired value, slide the throttle control lever from the bottom-most position (motor off)
to the full throttle position at once.
• 4 sounds are emitted as confirmation for the stored value.
• The speed controller returns to the programming mode, where you can call and set the next menu item if required.
The standard settings are displayed on a grey background in the table
4. Leaving the programming mode
• If the controller is in programming mode, wait until menu item 8 is acoustically displayed. Then slide the throttle
control lever from the full throttle position to the bottom-most position (motor off) within 3 seconds of the sound
signal. Depending on cell number, 2 – 6 brief sounds are emitted, followed by a slightly longer sound. The controller
is now ready for operation.
• Once the controller is in setting mode and you have stored a new value, pull the throttle control lever back to the
bottom position(motor off) right after the confirmation sound sequence. Depending on cell number, 2 – 6 brief
sounds are emitted, followed by a slightly longer sound. The controller is now ready for operation.
Technical Data
Power supply .................................................. 2 – 6 LiPo-cells or 5 – 18 NiMH-cells
Continuous current ......................................... 66 A
Peak current ................................................... 80 A
BEC output power .......................................... 5 V/3 A
Dimensions .................................................... 70 x 31 x 14 mm
Weight ........................................................... 60 g
1 x brief 2 x brief 3 x brief
Braking Off On
Battery type Lithium NiMH/NiCd
Cut-off mode soft hard
Cut-off switching threshold low medium high
Start mode normal soft very soft
Timing low medium high