background image

RC Boat 

Boat Antenna Tube

Transmitter 

Transmitter Antenna

Battery Tray 

User’s Guide

Please read this user’s guide before 

installing, setting up and using your new product

www.radioshack.com

what’s included

Antenna Tube Holder

Insert your boat’s antenna tube here.

Latches 

Turn to open the battery 
compartment. The power switch is 
located in the battery compartment.

Thank you for purchasing your RC 
Jet race Boat from 

RadioShack

Your boat comes in two 
frequencies (27MHz and 49MHz), 
so you and your friends can race 
together. The boat is equipped 
with a fan for cooling the motor. 
The automatic speed regulator 
enables smooth steering.

This vessel sails at high speeds. Avoid 

using it where people are swimming.

Caution:

 Immediately after recharging, the 

boat runs at a higher speed than normal, 

which can cause your boat to capsize 

on choppy water. Maneuver your boat 

carefully immediately after replacing the 

battery.

  Attach the antenna to your transmitter.

  Thread the boat’s antenna wire through 

the supplied antenna tube. Then, insert 

the tube into the antenna tube holder.

  Turn the latches on the boat to open the 

battery compartment and turn on the 

boat.

  Place your boat in the water and use the 

transmitter’s controls to operate it. Your 

transmitter’s LED lights when in use.

• Your transmitter does not have a power 

switch. It turns on when you move 

either lever.

• Your transmitter is not waterproof. Do 

not submerge it in water.

• The boat decreases its speed when 

turning to make sharper turns.

• When you finish playing, remove your 

boat from the water and shake excess 

water from your boat through the two 

drain holes.

sailing your boat

NOTES

•  Do not use your boat near devices with transmitters 

using the same frequency (27 or 49 MHz).

•  Running your boat continuously for long periods 

generates high heat levels, which cause wear and tear 

on the motor. To help keep heat levels down, let the 

boat cool at least 25 minutes before installing a fresh 

battery pack.

•  Keep your boat away from grass and debris that could 

cause propeller damage.

•  If your boat does not respond, drives slowly, or the 

range reduces, recharge your battery pack.

•  If your boat doesn’t respond after recharging, replace 

the transmitter battery and check for propeller debris.

•  If your boat slows down due to loss of battery power, 

guide it to shore immediately so it won’t drift away.

•  If your boat goes outside the transmitter’s range, it 

stops. Hold your transmitter high above your head to 

re-establish contact. If this doesn’t work, move closer 

and try again. Do not wade into deep water.

•  Never touch the propellers while they are spinning.
•  Children must be supervised by adults when playing 

with toys around water.

•  Do not operate the transmitter with the battery 

compartment open. The cooling fan in the boat starts 

when you operate the transmitter. 

safety information

LED

Release 

to stop

Left

Release 

to go 

straight

Forward

Right

Reverse

60-153

RC Jet Race Boat

Direct Alignment

 

If you can not drive the boat forward in a 
straight line, you can adjust the switch to left 
or right to adjust the boat forward. 

ON/OFF

60-153.indd   1

12/7/2006   11:15:15 AM

Reviews: