48
Chapter 4: Installing Components
www.gateway.com
■
If cable-select is available (drive assignments will be marked on the
cable), the IDE cable assigns the master/slave positions to the drives
it connects. You can override these assignments using the jumpers on
the drives.
■
If cable-select is not available and only one drive is attached to an IDE
controller cable, configure the drive as master if it is a CD drive. If
two drives of any type are attached to the cable, configure one as
master and one as slave.
■
You may need to configure the drives you install using the BIOS Setup
utility. Press
F2
at startup to open the BIOS Setup utility.
Installing a media drive
Use these instructions to install or replace a diskette, CD, or tape drive.
To install a 5.25-inch drive:
1
Follow the instructions in
“Preventing static electricity discharge” on
page 41
.
2
Follow the instructions in
“Opening the server case” on page 42
.
3
If you are replacing a drive, go to
Step 7
.
- OR -
Summary of Contents for 960
