95
Error messages
www.gateway.com
Error messages
These messages often indicate procedural errors such as typing an incorrect
keystroke or trying to save a file to a write-protected diskette. Some messages,
however, may indicate a problem that requires further troubleshooting.
Access denied
■
Your diskette is write-protected. Move the write-protection tab over the
window on the back of the diskette, or save to a new diskette.
Bad command or file name
■
Make sure that you entered the right command.
■
Make sure that the specified drive is correct, then try again.
■
If you are trying to exit MS-DOS to return to Windows, type
exit
, then
press
E
NTER
.
Base memory [xxx] expansion
■
This is an informational message only. No action is required.
CD drive is not recognized
■
See
“Your server does not recognize a CD or the CD drive” on page 102
for a possible solution.
Data error
■
In Windows 2000 Server, run CheckDisk on the drive with the error.
Diskette drive 0 seek to track 0 failed
■
Open the BIOS Setup utility, then make sure that the drive settings are
correct.
■
Check the diskette drive cables. Make sure that Pin 1 on the cable aligns
with Pin 1 on the connector.
Diskette drive reset failed
■
Open the BIOS Setup utility, then make sure that the drive settings are
correct.
■
Check the diskette drive cables. Make sure that Pin 1 on the cable aligns
with Pin 1 on the connector.
Summary of Contents for 960
