Gateway 9515, User Manual

Page: 75 / 194

70
www.gateway.com
6
Hold the sixth drive option board above and in front of the opening in the backplane.
7
Align the tabs in the option board with the holes in the backplane, then move the
board down and toward the back of the chassis to seat the board.
Make sure the bottom of the option board seats into the plastic retainer at the bottom
of the opening in the backplane.
8
Connect the end of the long SCSI cable labeled “Backplane” to the connector on the
sixth drive option board labeled “M/B,” then connect the remaining end of the cable
to the SCSI connector on the system board or SCSI add-in card.
9
Connect one end of the short SCSI cable labeled “Backplane” to the backplane
connector labeled “SCSI CH A,” then connect the other end to the sixth drive option
board SCSI connector on the back of the board.
10
Using the power cable labeled “Drive 5 Pwer” (included with the sixth drive option
kit), connect one end to the “OPT” connector on the sixth drive option board and
the other end to the “OPT END” connector on the backplane. See
“Hot-swap
backplane” on page 8 for connector locations.
11
Reinstall the fan module by following the instructions in “Replacing the fan module”
on page 85 .
12
Follow the instructions in “Closing the server case” on page 46 .